Hi!
I was wondering if it was possible to fit both the PAL en NTSC CPU/PPU in a NES?
The theory I had in mind was to cut or desolder the 5v pin from the board.
Solder a wire from the board to the middle leg of a switch.
a wire from the 5v pin of the PAL chip to one leg of the switch and from the other chip to the remaining leg on the switch.
After that solder all the other legs of the floating chip to the right place on the board and see if it works.
And if it does, give the chip a nice place in the case.
Will this work?
I was wondering if it was possible to fit both the PAL en NTSC CPU/PPU in a NES?
The theory I had in mind was to cut or desolder the 5v pin from the board.
Solder a wire from the board to the middle leg of a switch.
a wire from the 5v pin of the PAL chip to one leg of the switch and from the other chip to the remaining leg on the switch.
After that solder all the other legs of the floating chip to the right place on the board and see if it works.
And if it does, give the chip a nice place in the case.
Will this work?