The chip verified as empty fine but received an error at the end of programming. Are the jumpers for pcb 5.0e and pcb 3b supposed to be on 3 setting like I'm thinking? Here are the rest of my jumper settings. Also for the device select is it '27c080/801 (PCB3)' or something else?
http://i.imgur.com/j0sYtpE.jpg
Edit: I changed the bottom left 2 jumpers back to the left side so it's on 5.0E again and also brought my twp slider down to '55 µs' and this time it programmed and verified. I'm not sure if the twp slider helped but someone said to use the time the spec sheet lists which is 50 µs/word for ST M27C801. Going to wire it into a Stunt Race donor now and see if it boots.
Edit: http://i.imgur.com/IkEobmj.jpg
http://i.imgur.com/j0sYtpE.jpg
Edit: I changed the bottom left 2 jumpers back to the left side so it's on 5.0E again and also brought my twp slider down to '55 µs' and this time it programmed and verified. I'm not sure if the twp slider helped but someone said to use the time the spec sheet lists which is 50 µs/word for ST M27C801. Going to wire it into a Stunt Race donor now and see if it boots.
Edit: http://i.imgur.com/IkEobmj.jpg