I don't really understand , not sure if it's caused from my poor english or not.
What I don't understand is:
UNROM (mapper 2):
Bend up pins 1, 2, 24 and 31
Solder pin 2 to hole 22 (A16)
Solder pin 24 to GND (OE)
What about pin 22 that normally goes in hole 22 (PRG /CE)?
And what about pin 16 that normally goes in hold 16 (GND)?
Do I just leave them hanging in the air?
What I don't understand is:
UNROM (mapper 2):
Bend up pins 1, 2, 24 and 31
Solder pin 2 to hole 22 (A16)
Solder pin 24 to GND (OE)
What about pin 22 that normally goes in hole 22 (PRG /CE)?
And what about pin 16 that normally goes in hold 16 (GND)?
Do I just leave them hanging in the air?